Category: RepRap

Gift!

OhmEye, send me a gift that I am going to use on my MendelMax2. It was something I knew he would be sending and it...

My start and end G-Codes

Since my last post about my start and end G-Codes Slic3r has been updated, I found some ways of doing things I like better, so...

Filament pulley

After last batch of filament pulleys, I decided to try and use another technique to make the teeth. So far I have just used a...

Filament pulley

After last batch of filament pulleys, I decided to try and use another technique to make the teeth. So far I have just used a...

MM2 Upgrade: Extrusion ends

  This isn’t the worlds most complicated thing to do, but it makes the finished look a lot better.   The end caps can be found on...

MM2 Upgrade: Z thrust bearings

First post about my MM2 build, and here is one of the first things I am going to make different. I am upgrading my MM1.5...

Rumba, my functions, and pins

A while ago I received my Rumba board which is going to control my MendelMax2, and not only is it a pretty nice little board,...

Cheap-O firmware configuration

This is a bit about how to set up and adjust the Marlin firmware to use my Cheap-O end stop sensor correctly. File: Configuration.h Pull-Up...