MM2: Wire management – Part 2
November 16, 2013
In the last post I was worried about the wiring around the controller getting messy again, as the wires for all the end-stops still had to be added… But as you can see, I did it without really messing anything up!
Here the wire for the Y-min end-stop is ready, and just outside the left side of the picture the wire for X-min is going into the vertical cable carrier.
The wires for Z-min follow the power wires going into the controller a bit, and going all the way to the back of the printer, then a bit towards the front again to not have to have some extra wires just going across to make them shorter.