MM2 Upgrade: Extrusion ends
April 2, 2013
This isn’t the worlds most complicated thing to do, but it makes the finished look a lot better.
The end caps can be found on adafruit‘s page, and will require a bit of hammering to get in, specially if you like me got thread in at the same time.
About The Author
Mikey
3 Comments
Wow, Adafruit’s is cheaper. Those caps, or ones that do the same job, can be bought from Misumi. I bought a bunch in anticipation of the MM2, plus other anticipated projects. Part # HFC5-2020-B $0.81 each. But they don’t require a mallet to install, and they don’t fall out either.
Wow, Adafruit’s is cheaper. Those caps, or ones that do the same job, can be bought from Misumi. I bought a bunch in anticipation of the MM2, plus other anticipated projects. Part # HFC5-2020-B $0.81 each. But they don’t require a mallet to install, and they don’t fall out either.
Wow, Adafruit’s is cheaper. Those caps, or ones that do the same job, can be bought from Misumi. I bought a bunch in anticipation of the MM2, plus other anticipated projects. Part # HFC5-2020-B $0.81 each. But they don’t require a mallet to install, and they don’t fall out either.